Citaat van: CBdicX op december 10, 2024, 12:10:04Ik heb altijd nog een zeer bescheiden Yamaha sub(je) beschikbaar, volgens mij iets van 6 inch en 75 watt......
Misschien dat ik die toch mee neem in de setup omdat er dan wat meer mogelijkheden actief worden.
Een van de mogelijkheden van de C40 is het bepalen van de hoeveelheid LFE wat naar de frontspeakers gestuurd wordt, naar de Center en andere speakers (niet naar de sub).
Dacht dat er de keuze was, 0 alles naar de speakers, en 0 / -20 minder naar de speakers.
En dan gewoon uit laten, of zoals hier vermeld zachtjes laten "mee pruttelen", maar horen wil ik em zeker niet
Je hebt onder Setup/Speaker/Advanced/Low Frequency Effect een optie 'Distribution'. Daar bepaal je hoeveel van het LFE signaal je naar de fronts wilt sturen.
Ik quote even Gene van Audioholics "IF you turn off the sub channel on most modern AVRs from Denon, Marantz, Yamaha, etc, the LFE will be re-routed to the mains. Sometimes this can be a bit too much LFE especially if your mains aren't up for the task so you should lower the LFE level at least 3-6dB (different than the sub level) if you're planning on doing this.
In most cases, I don't recommend this type of configuration. If you have true bass capable mains, get a new Denon/Marantz AVR with LFE routing so you can route LFE to them and still have dedicated sub channels with bass management and LFE routing. They added this feature because I kept bugging them for it. Works great on the Marantz AV10 as long as you don't use DIRAC."
Ook elders zegt Gene om heel voorzichtig te zijn met die optie."Caution About LFE Bass Routing: This is a first for any Japanese based AVPs or receivers and I am so ecstatic about this. This feature is typically reserved for the very high-end processors from the likes of Trinnov and Storm Audio. I do caution users to use this feature with great caution and ONLY if your un-bass managed speakers are capable of handling deep LFE bass effects (most tower speakers are NOT). I would also suggest starting at -6dB to -10dB and NOT leave it at the default 0dB."