Citaat van: pg op augustus 08, 2009, 23:12:48
heb de pm 7003 en pm 8003 geluisterd en de verschillen zijn klein heel klein op mijn monitor.
misschien als de speaker wat meer ga vragen is het verschil en kan er iemand dat uit liggen voor hem.
Dynaudio is niet zo'n amp-killer...
daarbij zijn dit de specs van beide versterkers:
pm7003
Current Feedback 2 x 70 watts (8 ohms) power amplification
New solid reference standard chassis
High-speed instantaneous current supply power amplifier design
Fast signal handling and extended frequency range
Marantz current feedback Hyper Dynamic Amplifier Modules HDAM
Symmetric circuit architecture
Linear Drive Power Supply
High-grade audio components
Source Direct function for best sound quality
Six audio inputs including phono (MM)
Tone control
Amp direct mode for operation as power amplifier only (for bi-amp mode or extension of A/V-Receiver)
Two pair of speaker outputs – A/B
Detachable power cord
System remote control and Marantz D-Bus
pm8003
Purist reproduction expressing the essence and emotion of music
2 x 70 watts (8 Ohm RMS) power amplification
New solid reference standard chassis
Current Feedback technology for fast signal handling and extended frequency range
Toroidal transformer for instantaneously current delivery capability
Marantz Current Feedback HDAMs
Customised components and symmetric circuit topology
Rigid dual layer chassis construction virtually eliminates any mechanical vibration
Copper-plated chassis and back panel for lowest impedance grounding
Source Direct function for finest sound quality, which bypass the tone control
Amp Direct mode for operation as power amplifier only (for bi-amp mode or extension of A/V-Receiver)
Current feedback topology phono stage
Speaker terminal A/B with custom made Marantz terminals
Detachable power cord
System remote control and Marantz D-Bus