Citaat van: Stadium III op februari 19, 2011, 19:21:19
DV 7001 was wel te oen aan huis
V09 was iig de laaste en loste HDMI problemen op
Ik heb die laatste versie nog wel als zip-bestand. Stuur me maar even een PM dan zal ik 'm naar je emailen.
Bestand even branden op CD-ROM en hoppa!
Hieralvast de procedure:
Procedure:
•Download the file DV7001.bin
•Burn this file on a data CD-R (adjust the burn program so, that only one
recording is possible on this disc, in other words "close session", file format is iSO9660 and Write Format DISC AT ONCE)
Important: During the below mentioned procedure, do not switch off the set or
disconnect the mains cable from the set unless noticed. This will interrupt the
upload process and damage the DVD player. This is not covered by warranty.
•Connect the DVD player to a display unit (e.g. Television set)
•Switch ON the DVD player.
•Open the tray by pressing the OPEN/CLOSE button
•Put the data CD-R on the DVD tray.
•Close the DVD tray.
•The CD-R will be red and "LOAD" is displayed on the DVD front panel. (and "Loading" on the display unit)
•The display unit shows: "UPGRADE FILE DETECTED" and "FILE COPING" (very short) and next the message "FILE COPING" will be changed to: "UPGRADING"
•The tray opens automatically (DO NOT SWITCH OFF THE SET).
•Remove now the CD-R from the tray (tray will stay open).
•The display of the DV7001 will show "ERASE" and this will change to
"WRITE" (display unit will still show "UPGRADE FILE DETECTED
UPGRADING"). This takes about 90 seconds.
•After that the display of the DV7001 will show "UPG END"
•Now the DVD player will be resetted and the tray will be closed automatically.
•Press the POWER button to switch off the set. (the set is now upgraded)
Checking if the upgrade is done successfully:
•Leave the DVD player connected to the display unit.
•Press the POWER button to switch ON the unit.
•Open the tray by pressing the OPEN/CLOSE button.
•Press the button DISP on the remote control of the DVD player.
•Make sure that the text
"V09" is present in the following line, displayed on the display unit: DV7001 V09 V701-12 3
