Marantzforum.nl

Marantz => Techniek => Topic gestart door: andré3010 op oktober 01, 2010, 16:20:02

Titel: Marantz SR 4002
Bericht door: andré3010 op oktober 01, 2010, 16:20:02
Hallo,

Ik ben in bezit van een Marantz SR 4002, tot voor kort een prima apparaat.
Ik heb per ongeluk de luidsprekers losgemaakt tijdens het spelen.
Nu knippert de power rode led.
Weet iemand een oplossing voor mijn probleem??
Titel: Re: Marantz SR 4002
Bericht door: Stadium III op oktober 01, 2010, 19:24:47
Enter knop indrukken op reciever
Mopcht dit niet lukken staat in de handleiding hoe je hem eruit moet halen
Titel: Re: Marantz SR 4002
Bericht door: andré3010 op oktober 04, 2010, 09:06:54
Beste stadium III,

De enter funktie zoals jij beschreven werkt niet.
Ik ben op zoek gegaan naar de handleiding en kan hem nergens meer vinden, misschien heeft iemand anders hem nog.
Titel: Re: Marantz SR 4002
Bericht door: andré3010 op oktober 11, 2010, 17:53:52
Hallo,
Ik heb de gebruiksaanwijzing gevonden, maar er staat niets over hoe de sr4002 uit de beveiliging moet worden gehaald.

Misschien kan STADIUM III het wel vinden???
Titel: Re: Marantz SR 4002
Bericht door: Stadium III op oktober 11, 2010, 19:05:28
Moet achter in staan
Zal eens gaan zoeken voor je
Titel: Re: Marantz SR 4002
Bericht door: Stadium III op oktober 11, 2010, 19:09:28
http://www.marantz.eu/attachments/products/111/SR4002_manual_en.pdf (http://www.marantz.eu/attachments/products/111/SR4002_manual_en.pdf)

En dan doe je dit : (pagina 47 van de handleiding zelf )

.
HOW TO RESET THE UNIT
Should the operation or display seem to be abnormal,
reset the unit with the following procedure.
To turn on the SR4002, press and hold the 7.1CH
INPUT and ATT buttons simultaneously for 3 seconds
or more.
To turn on the SR5002, press and hold the MULTI
and ATT buttons simultaneously for 3 seconds or
more.
Remember that the procedure will reset the settings
of the SOURCE, Surround mode, delay time, TUNER
PRESET etc., to their initial settings.
Titel: Re: Marantz SR 4002
Bericht door: andré3010 op oktober 12, 2010, 20:03:57
Beste Staduim III,

Wat op blz. 47 links onderaan staat vermeld heeft niets met mijn klacht te maken. (knipperede led een geen display).
Dit betreft een terugstelling naar de basis instellingen.
Ik weet lezen is moeilijk.
Titel: Re: Marantz SR 4002
Bericht door: Stadium III op oktober 12, 2010, 20:19:11
Suc 6 iig ermee !
Titel: Re: Marantz SR 4002
Bericht door: lo op oktober 12, 2010, 20:24:01
 :-o Je hebt toch geen kritiek op stadium III hè?
Heb je zelf de handleiding al gelezen?
Ik heb eea gevonden op blz 51 van de handleiding waar stadium III de link van had geplaatst, waarin volgens mij de ingredienten zoals jij ze noemt worden aangehaalt.
Gaat over een knipperende "standby indicator".

Sometimes, when "PROTECT" is shown on the unit's display, the standby indicator fl ashes slowly (twice a second).
When this happens, turn off the unit's power and remove the power cable. Then follow the procedure described below:
• Check to ensure that the speaker cables connected to the unit have not been connected with + and - connections reversed.
(Check that the playback volume is not greater than the unit can handle.)
• Check that the playback volume is not greater than the unit can handle.
After completing the above checks, connect the power cable and switch the unit back ON using the remote control.
Then, after reducing the volume, start playback and check that "PROTECT" is not appearing on the display and that there is no problem with speaker connections to the unit or
with sound reproduction.
If the same problem re-occurs, please contact your local service center to have it repaired.
On rare occasions, the unit will go into standby mode with the standby indicator fl ashing rapidly (eight times a second).
When this happens, it means that some major problem has occurred with the unit.
Quickly disconnect the power cable and take the unit to your local service center to have it repaired.
Titel: Re: Marantz SR 4002
Bericht door: Sander op oktober 12, 2010, 20:48:27
Omdat deze vraag best wel eens voor komt heb ik maar even de moeite genomen om de nederlandse handleiding in te scannen.

Hoop dat je er wat aan hebt.

Grtz Sander
Titel: Re: Marantz SR 4002
Bericht door: andré3010 op oktober 13, 2010, 15:21:05
Hallo Sander,
Bedankt voor de moeite, ik schreef al eerder dat ik de gebruiksaanwijzing had gevonden.
Dit alles is niet de oplossing.
Titel: Re: Marantz SR 4002
Bericht door: andré3010 op oktober 13, 2010, 15:30:30
Hallo Io,

Als je alle bovenstaande reactie's goed had gelezen was het niet nodig geweest om zo te reageren.
Trouwens het staat op pagina 47 van de gebruiksaanwijzing i.p.v 51 die jij vermeld.(zowel in nederlandse als engelse taal)
Titel: Re: Marantz SR 4002
Bericht door: lo op oktober 13, 2010, 16:45:26
Hoe bedoel je, "zo te reageren"?

Ik heb de handleiding waarvan stadiumIII de link had geplaatst gelezen en bij mij staat in de pdf dezelfde tekst zoals, Sander Nolden deze had geplaats,t op blz 51.

Als dit niet je probleem verhelpt zou ik contact opnemen met de leverancier.

groet,

lo
Titel: Re: Marantz SR 4002
Bericht door: andré3010 op oktober 14, 2010, 12:43:35
Iedereen bedankt voor de bijdrage, helaas zonder resultaat.
Weet iemand soms waar de centrale reparatie Marantz in Nederland zit?
Ik wil mijn app. niet bij de leverancier achterlaten.

Groet,
Andre3010
Titel: Re: Marantz SR 4002
Bericht door: lo op oktober 14, 2010, 13:37:50
Elst

http://www.audioservice.nl/
Titel: Re: Marantz SR 4002
Bericht door: andré3010 op oktober 22, 2010, 18:16:50
Hallo Stadium III,

Na ons gesprek van afgelopen week en later nog met audioservice in Elst gebeld, heb ik besloten een nieuw app. te kopen en het oude app. af te voeren naar de stadsreiniging.
Nogmaals vriendelijk dank voor alle medewerking en misschien tot horens.

Andre3010