Je hebt toch geen kritiek op stadium III hè?
Heb je zelf de handleiding al gelezen?
Ik heb eea gevonden op blz 51 van de handleiding waar stadium III de link van had geplaatst, waarin volgens mij de ingredienten zoals jij ze noemt worden aangehaalt.
Gaat over een knipperende "standby indicator".
Sometimes, when "PROTECT" is shown on the unit's display, the standby indicator fl ashes slowly (twice a second).
When this happens, turn off the unit's power and remove the power cable. Then follow the procedure described below:
• Check to ensure that the speaker cables connected to the unit have not been connected with + and - connections reversed.
(Check that the playback volume is not greater than the unit can handle.)
• Check that the playback volume is not greater than the unit can handle.
After completing the above checks, connect the power cable and switch the unit back ON using the remote control.
Then, after reducing the volume, start playback and check that "PROTECT" is not appearing on the display and that there is no problem with speaker connections to the unit or
with sound reproduction.
If the same problem re-occurs, please contact your local service center to have it repaired.
On rare occasions, the unit will go into standby mode with the standby indicator fl ashing rapidly (eight times a second).
When this happens, it means that some major problem has occurred with the unit.
Quickly disconnect the power cable and take the unit to your local service center to have it repaired.
